Installation procedure version 1.8.2 using SOFTWARE COMPONENT

In this release two new support packages are released:

SP14 for component TESII → TESII_100_700_SP14.SAR
SP15 for the TESIICNC component → TESIICNC_100_700_SP15.sar
SP16 for the TESIICNC component → TESIICNC_100_700_SP16.sar

These files can be downloaded from the One Place portal in the Facilities section - b + SII, version 1.8.2:

Pre requirements

Have the Licensing component installed: 2.1 Installation of the BPCORE Licensing Component (if it has not been previously installed with version 1.7.4). All you have to do is have the component installed to carry out the installation, you don't have to wait to have the corresponding active licenses.
To install this version it is necessary to have the TEAL Software Component installed up to SP2.

IMPORTANT: This component was already a prerequisite in version 1.8.0

To install SP14 for TESII it is necessary to have the TESII Software Component installed up to SP13.
To install SP15 for TESIICNC it is necessary to have the TESIICNC Software Component installed up to SP14.
To install SP16 for TESIICNC it is necessary to have the TESIICNC Software Component installed up to SP15.

If these last three requirements are not met, the missing SPs of both components must be loaded into the installation queue until the SPs that are released in this version.

The SPs from the initial version to version 1.7.8 are in version 1.7.8 of One Place and the rest of the SPs are each in their corresponding release version

Attention!

DO NOT PUT THE TESII SP5 (version 1.7.4) and TESII UPPER SPs TOGETHER IN THE INSTALLATION QUEUE. INSTALL SEPARATELY.

If for some reason, in the installation process, the TESII SP5 and higher SPs have been installed at the same time in the same transport queue of the SAINT, two errors can occur in the IMPORT_PROPER phase. Consult the following page in case of errors in this phase: Errors in the IMPORT_PROPER phase during the installation of the Add-On.

To check which release of each component the system is in, you can check the status by accessing from "System" in the top menu:

If you need to download SPs older than the SPs that are released in this version, you can consult the following link, Installable files section, from where to download these files: 1.1.2.3. Installation procedure ECC as a Software component.

Installation Tasks

Install the Alarm Component as indicated in the prerequisites.
Install TESIICNC SP14 TESII SP15 and TESIICNC SP16 as follows:

Log in to the system in English with client 000.

SPAM transaction.

Load the three files for installation, SP14 for TESII and SP15., SP16 for TESIICNC. (If necessary, load the previous SPs as indicated in the prerequisites).

Once loaded, press

Then select the TESII component.

The SPs pending to be installed will appear in green.

Press the green check and in the next pop up, press NO.

Press the release icon.

Select background installation.

If the SPAU and SPDD jump during this process, make the necessary adjustments.

Once the process is finished, press the confirm queue icon.

Check that they have been installed correctly:

Activation of the BC_SETs

Once the SPs necessary for version 1.8.2 have been installed, it will be necessary to activate the BC_SETs that offer the necessary parameterization for the correct operation of this version: https://techedgespain.atlassian.net/wiki/spaces/BSE/pages/2154397835