Three new support packages are released in this release:
SP11 for the TESII component → TESII_100_700_SP11.SAR
SP11 for component TESIICNC → TESIICNC_100_700_SP11.sar
SP12 for component TESIICNC → TESIICNC_100_700_SP12.sar
These files can be downloaded from the customer portal in the Installations section - B+ SII, release 1.7.9.1 via software component.
Pre requirements
To have installed the component of Licenses: 1.1.2.1 Installation of License Component BPCORE (if not previously installed with version 1.7.4). It is enough to have the component installed to carry out the installation, it is not necessary to wait for the corresponding active licenses.
To install SP11 for TESII it is necessary to have the TESII Software Component installed up to SP9.
To install SP11 and SP12 for TESIICNC it is necessary to have installed the TESIICNC Software Component up to SP9.
If these last two requirements are not met, it is necessary to load in the installation queue the SPs of both components that are missing until the SPs that are released in this version.
Caution!
DO NOT PLACE TESII SP5 (version 1.7.4) and TESII TOP SPs TOGETHER IN THE INSTALLATION QUEUE. INSTALL SEPARATELY.
If for some reason, in the installation process, the higher TESII SP5 and SPs have been installed at the same time in the same SAINT transport queue, two errors may occur in the IMPORT_PROPER phase. See the next page in case of errors in this phase: Errors in phase IMPORT_PROPER during the installation of the Add-On
To check which release of each component the system is in, you can consult the status by accessing it from "System" in the upper menu:
If you need to download SPs prior to the SPs released in this version, you can consult the following link, section Installable files, from where to download these files: 1.1.2.3 ECC Installation procedure as a Software Components
Installation Tasks
Installation of SP11 TESII and SP11 and SP12 TESIICNC
Log in the system in English with the client 000.
SPAM transaction.
Upload the three files for the installation, SP11 for TESII and SP11 and SP12 for TESIICNC. (If it is necessary to load the previous SPs as indicated in the prerequisites).
Once loaded, press
Then select the TESII component.
The pending SPs to instal will appear in green.
Press the green check and in the next pop up, press NO.
Press the release icon.
Select the installation in background.
If during this process the SPAU and SPDD appear, make the necessary adjustments.
Once the process is finished, click on the confirm queue icon.
Check that it has been installed correctly:
BC_SETs Activation
Once the SPs necessary for version 1.7.9.1 have been installed, it will be necessary to activate the BC_SETs that offer the necessary parameterization for the correct operation of this release: https://techedgespain.atlassian.net/wiki/spaces/BSE/pages/1089405414/Activation+BC+SETs+version+1.7.9.1 .