...
These files can be downloaded from the customer portal in the installation section, release 1.7.5, using software components:
Pre-requisites
- Have the Licensing component installed: 1.1.2.1 Installation of License Component BPCORE (if not previously installed with version 1.7.4). It is enough to have the component installed to carry out the installation, it is not necessary to wait for the corresponding active licenses.
- To install SP6 for TESII you need to have the TESII Software Component installed up to SP5.
- To install SP5 for TESIICNC you need to have the TESIICNC Software Component installed up to SP4.
...
Once you have reached the SP level indicated above (TESII SP5, TESIICNC SP4), load the files of version 1.7.5 (SP6 TESII, SP5 TESIICNC) in the installation queue.
Attention!
DO NOT PLACE SP5 OF TESII AND SP6 OF TESII TOGETHER IN THE INSTALLATION QUEUE. INSTALL SEPARATELY.
If for some reason, in the installation process, TESII SP5 and SP6 have been installed simultaneously in the same SAINT transport queue, two errors may occur in the IMPORT_PROPER phase. Refer to the following page in case of errors in this phase: Errors in phase IMPORT_PROPER during the installation of the Add-On.
To check which release of each component the system is in, you can check the status by going to the "System" tab in the top menu:
...