Installation procedure release 1.7.5 using SOFTWARE COMPONENT
In this release two new support packages are released:
- SP6 for the TESII component → TESII_100_700_SP6.sar
- SP5 for component TESIICNC → TESIICNC_100_700_SP5.sar
These files can be downloaded from the customer portal in the installation section, release 1.7.5, using software components:
Pre-requisites
- Have the Licensing component installed: 1.1.2.1 Installation of License Component BPCORE (if not previously installed with version 1.7.4). It is enough to have the component installed to carry out the installation, it is not necessary to wait for the corresponding active licenses.
- To install SP6 for TESII you need to have the TESII Software Component installed up to SP5.
- To install SP5 for TESIICNC you need to have the TESIICNC Software Component installed up to SP4.
If these last two requirements are not reached, a previous installation must be made to reach this patch level. To do this, load the SPs of both components into the installation queue up to TESII SP5 and TESIICNC SP4 and install.
Once you have reached the SP level indicated above (TESII SP5, TESIICNC SP4), load the files of version 1.7.5 (SP6 TESII, SP5 TESIICNC) in the installation queue.
Attention!
DO NOT PLACE SP5 OF TESII AND SP6 OF TESII TOGETHER IN THE INSTALLATION QUEUE. INSTALL SEPARATELY.
If for some reason, in the installation process, TESII SP5 and SP6 have been installed simultaneously in the same SAINT transport queue, two errors may occur in the IMPORT_PROPER phase. Refer to the following page in case of errors in this phase: Errors in phase IMPORT_PROPER during the installation of the Add-On.
To check which release of each component the system is in, you can check the status by going to the "System" tab in the top menu:
If you need to download SPs prior to the SPs that are released in this version, you can consult the following link, section Installable files, where to download these files from:1.1.2.3 ECC Installation procedure as a Software Components
Installation Tasks
Installing SP6 TESII and SP5 TESIICNC
Log on to the system in English with client 000.
SPAM transaction.
Load the two files for the installation, SP6 for TESII and SP5 for TESIICNC (If necessary, load the previous SPs as indicated in the prerequisites).
Once loaded, press
Then, you select the TESII component.
The SPs to be installed will appear in green.
Press the green check and in the next pop up, press NO.
Press the release icon.
Select the installation in the background.
If the SPAU and SPDD are skipped during this process, make the necessary adjustments.
Once the process is finished, click on the queue confirmation icon.
Check that they have been installed correctly:
Activation of BC_SETs
Once the necessary SPs for release 1.7.5 have been installed, it will be necessary to activate the BC_SETs that offer the necessary parameterization for the correct operation of this release:Activation of BC_SETs release 1.7.5
Related content
Avvale 2024