In this release two new support packages are released: SP13 for component TESII → TESII_100_700_SP13SAR SP14 for the TESIICNC component → TESIICNC_100_700_SP14.sar These files can be downloaded from the One Place portal in the Facilities section - b + SII, version 1.8.0:
Pre requirements
Have the Licensing component installed: 2.1 Installation of the BPCORE Licensing Component (if it has not been previously installed with version 1.7.4). All you have to do is have the component installed to carry out the installation, you don't have to wait for the corresponding active licenses.
To install this version it is necessary to have the TEAL Software Component installed up to SP2.
IMPORTANT: This component was already a prerequisite in version 1.8.0
To install SP13 for TESII it is necessary to have the TESII Software Component installed up to SP12.
To install SP14 for TESIICNC it is necessary to have the TESIICNC Software Component installed up to SP13.
If these last two requirements are not met, the missing SPs of both components must be loaded into the installation queue until the SPs that are released in this version.
Attention!
DO NOT PUT THE TESII SP5 (version 1.7.4) and TESII UPPER SPs TOGETHER IN THE INSTALLATION QUEUE. INSTALL SEPARATELY.
If for some reason, in the installation process, TESII SP5 and higher SPs have been installed at the same time in the same SAINT transport queue, two errors can occur in the IMPORT_PROPER phase. Consult the following page in case of errors in this phase: Errors in the IMPORT_PROPER phase during the Add-On installation.
To check which release of each component the system is in, you can check the status by accessing "System" in the top menu:
