In this release two new support packages are released: SP13 for component TESII → TESII_100_700_SP13SAR SP14 for the TESIICNC component → TESIICNC_100_700_SP14.sar These files can be downloaded from the One Place portal in the Facilities section - b + SII, version 1.8.01:
...
Pre requirements
Have the Licensing component installed: 2.1 Installation of the BPCORE Licensing Component(if it has not been previously installed with version 1.7.4). All you have to do is have the component installed to carry out the installation, you don't have to wait for the corresponding active licenses.
To install this version it is necessary to have the TEAL Software Component installed up to SP2.
...
If these last two requirements are not met, the missing SPs of both components must be loaded into the installation queue until the SPs that are released in this version.
| Nota |
|---|
The SPs from the initial version to version 1.7.8 are in version 1.7.8 of One Place and the rest of the SPs are each in their corresponding release version |
Attention!
DO NOT PUT THE TESII SP5 (version 1.7.4) and TESII UPPER SPs TOGETHER IN THE INSTALLATION QUEUE. INSTALL SEPARATELY.
...