In this release two new support packages are released: SP13 for component TESII → TESII_100_700_SP13SAR SP14 for the TESIICNC component → TESIICNC_100_700_SP14.sar These files can be downloaded from the One Place portal in the Facilities section - b + SII, version 1.8.01:
...
Pre requirements
Have the Licensing component installed: 2.1 Installation of the BPCORE Licensing Component(if it has not been previously installed with version 1.7.4). All you have to do is have the component installed to carry out the installation, you don't have to wait for the corresponding active licenses.
To install this version it is necessary to have the TEAL Software Component installed up to SP2.
...
If these last two requirements are not met, the missing SPs of both components must be loaded into the installation queue until the SPs that are released in this version.
| Nota |
|---|
The SPs from the initial version to version 1.7.8 are in version 1.7.8 of One Place and the rest of the SPs are each in their corresponding release version |
Attention!
DO NOT PUT THE TESII SP5 (version 1.7.4) and TESII UPPER SPs TOGETHER IN THE INSTALLATION QUEUE. INSTALL SEPARATELY.
...
If you need to download SPs older than the SPs that are released in this version, you can consult the following link, Installable files section, where to download these files: 2.2. Installation procedure ECC as a Software component.
Installation Tasks
Install the Alarm Component as indicated in the prerequisites.
Install TESII SP13 and TESIICNC SP14 as follows:
Log in to the system in English with client 000.
...
SPAM transaction. Load the three files for installation, SP12 for TESII and SP13 for TESIICNC. (If necessary, load the previous SPs as indicated in the prerequisites).
...
Once loaded, press
...
Then select the TESII component.
...
The SPs pending installation will appear in green.
...
Press the green check and in the next pop up, press NO.
...
Press the release icon.
...
Select background installation. If the SPAU and SPDD jump during this process, make the necessary adjustments. Once the process is finished, press the confirm queue icon.
...
Check that they have been installed correctly:
...
Activation of BC_SETs Once the SPs necessary for version 1.8.1 have been installed, it will be necessary to activate the BC_SETs that offer the necessary parameterization for the correct operation of this version: https://techedgespain.atlassian.net/wiki/spaces/BSE/pages/1704133737/Activation+BC+SETs+version+1.8.1