Three new support packages are released in this release:
- SP8 for component TESII → TESII_100_700_SP8.SAR
- SP8 for the component TESIICNC → TESIICNC_100_700_SP8.sar
These files can be downloaded from the customer portal in the installations section, version 1.7.7 using the software component.
Prerequisites
- To have installed the component of Licenses: 2.1 Installation of the Component of Licenses BPCORE (if it has not been installed previously with the version 1.7.4). It is enough to have the component installed to carry out the installation, it is not necessary to wait for the corresponding active licenses.
- To install SP8 for TESII it is necessary to have the TESII Software Component installed up to SP7.
- To install SP8 for TESIICNC it is necessary to have installed the TESIICNC Software Component up to SP7.
If these last two requirements are not met, it is necessary to load in the installation queue the SPs of both components that are missing until the SPs that are released in this version.
Warning!
DO NOT PLACE TESII SP5 (version 1.7.4) and TESII TOP SPs TOGETHER IN THE INSTALLATION TAIL. INSTALL SEPARATELY.
If for some reason, during the installation process, the higher TESII SP5 and SPs have been installed at the same time in the same SAINT transport queue, two errors may occur in the IMPORT_PROPER phase. See the following page in case of errors in this phase: Errors in IMPORT_PROPER phase during Add-On installation.
To check which release of each component the system is in, you can consult the status by accessing it from "System" in the upper menu:
If you need to download SPs prior to the SPs released in this version, you can consult the following link, section Installable files, where to download these files: 2.2. Procedure for installing ECC as a Software component
Installation Tasks
Installation of SP8 TESII and SP8 TESIICNC
Log in the system in English with the client 000.
Once loaded, press 
