In this release two new support packages are released: SP13 for component TESII → TESII_100_700_SP13SAR SP14 for the TESIICNC component → TESIICNC_100_700_SP14.sar These files can be downloaded from the One Place portal in the Facilities section - b + SII, version 1.8.0:
...
If you need to download SPs older than the SPs that are released in this version, you can consult the following link, Installable files section, where to download these files: 2.2. Installation procedure ECC as a Software component.
Installation Tasks
Install the Alarm Component as indicated in the prerequisites.
Install TESII SP13 and TESIICNC SP14 as follows:
Log in to the system in English with client 000.
...
SPAM transaction. Load the three files for installation, SP12 for TESII and SP13 for TESIICNC. (If necessary, load the previous SPs as indicated in the prerequisites).
...
Once loaded, press
...
Then select the TESII component.
...
The SPs pending installation will appear in green.
...
Press the green check and in the next pop up, press NO.
...
Press the release icon.
...
Select background installation. If the SPAU and SPDD jump during this process, make the necessary adjustments. Once the process is finished, press the confirm queue icon.
...
Check that they have been installed correctly:
...
Activation of BC_SETs Once the SPs necessary for version 1.8.1 have been installed, it will be necessary to activate the BC_SETs that offer the necessary parameterization for the correct operation of this version: “Falta enlace“